Industry News- Jiangsu Wopeng Power Technology Co., Ltd

Busbar Fabrication Guide: Process Steps, Materials, and Quality Control

Sep 08, 2026

At 3 p.m. on the hottest afternoon of the year, a 4,000 A switchboard in a coastal plant trips for the third time that week. The design was sound and the breaker tested fine. The real culprit: a bol...
View More +
Aluminum Bus Bar Ampacity Chart: Sizes, Temperature Rise and Selection Tips

Sep 01, 2026

Ask two catalogs what a 100 × 10 mm aluminum bar can carry and you may get two different answers — 800 A from one, 965 A from another. Both can be right, because an aluminum bus bar ampacity chart is...
View More +
Copper Bus Bar Ampacity: Sizing Guide, Charts, and Buying Factors for Engineers

Aug 25, 2026

The ampacity question is also a temperature question A 100 x 10 mm copper bus bar can look like a safe choice for a 1000 A switchboard until it is installed in a sealed enclosure with other bars pac...
View More +
Bus Bar Insulators: Types, Materials, Selection, Common Mistakes & Standards

Aug 18, 2026

Bus bar insulators rarely get attention during routine operation, until a flashover takes down a switchgear section or a cracked support allows a busbar to sag. The insulator is the only component st...
View More +
Copper Ampacity Chart: How to Read & Size Busbars | Busbars Factory

Aug 11, 2026

Selecting the correct copper conductor size for an industrial power distribution project often starts with a single question: how much current can this bar or cable safely carry? A copper ampacity ch...
View More +
Fully Insulated Tubular Bus Bar: PTFE vs Epoxy vs EPDM Guide

Aug 04, 2026

A Fully Insulated Tubular Bus Bar is a hollow copper or aluminum conductor wrapped in a continuous dielectric layer such as PTFE, cast epoxy resin, or EPDM silicone rubber, built to carry high curre...
View More +
How to Select Medium-Low Voltage Bus Bar Specifications？

Jul 28, 2026

The correct specification for a medium and low voltage bus bar is fixed by four numbers in this order: system voltage class, rated current under peak load, short-circuit withstand current, and ambien...
View More +
How to Prevent Oxidation on Aluminum Busbar Connections？

Jul 21, 2026

Oxidation on aluminum busbar connections is prevented by removing the natural oxide layer mechanically, applying an oxidation-inhibiting joint compound immediately after cleaning, using the correct ...
View More +
What insulation materials are used for fully insulated tubular bus bars？

Jul 14, 2026

Fully insulated tubular bus bars rely on three primary insulation materials: PTFE (polytetrafluoroethylene), epoxy resin casting compound, and EPDM silicone rubber. Each material is selected based on...
View More +
What is a Power Busway?

Jul 07, 2026

A power busway is a prefabricated, fully enclosed electrical distribution system that carries current through solid copper or aluminum conductors housed inside a metal enclosure, replacing bundles of...
View More +
What Is a High and Low Voltage Busway System and How Should You Select One?

Jun 30, 2026

Technical Deep Dive A high and low voltage busway system is the engineering benchmark for large-scale power distribution — replacing cable-and-conduit runs with factory-engineered enclosed conductor...
View More +
Can compact busway handle the same current as traditional bus duct?

Jun 23, 2026

Compact Busway vs Traditional Bus Duct: Current Capacity Comparison Compact busway can handle the same current as traditional bus duct, and in many cases, it performs even better. Both systems share ...
View More +

Industry News

News

Product Categories